| Name |
SW-303 MANGANESE WASH 4 OZ MAYCO |
| Description |
Manganese Wash fires to a warm metallic finish that breaks brown over texture. When used in combination, Manganese Wash will add some brown variation and movement to the glaze(s). The amount of mobility produced when using Manganese Wash in combination is dependent upon how much of each product was applied; how many coats of each and how many different products are being used; and the performance of the glaze it is being paired with. For example, layering Manganese Wash with a glossy glaze that breaks over texture will create more movement than layering it with an opaque matte glaze. We recommend only applying Manganese Wash to the top 2/3 of a piece when layering with other glazes because of the movement produced when layering. It works great when applied with a brush around the rim of a piece or applied with a glaze trailer in a pattern. Manganese Wash also works great as a body stain. Applying clear glaze can lessen the appearance of staining.
Cone 6: Manganese Wash fires to a warm metallic finish that breaks brown over texture.
Cone 10: No change. |
| Temperature Range |
Cone 04-10. Chips shown are fired to cone 6. |
| Qualities |
Not Dinnerware Safe |
| Other Information |
METALLIC GLAZE COLORANTS
Washes can be applied in a variety of ways, but are often painted into textured areas and wiped away on the higher surface to accentuate the texture.
GENERAL USE
Shake for 5-6 seconds before use. Stir well. Dispense amount needed into a separate container and thin with water. Dispensing the glaze onto a palette (tile, plate, etc.) – helps prevent against contamination of the contents in the jar. Washes are highly concentrated so adding water is recommended. Mix only the amount you plan to use in one session. For all-over coverage, brush on one to two coats; allow to dry in-between each coat. Can be fired from cone 06 to cone 9/10. Washes can be applied to greenware and bisque. The choice of clay body, the thickness of glaze application, firing process and temperature will affect the fired results. Always test in your kiln, on your clay body. |
| MSDS |
SDS Sheets |